Z Microsystems ZX3 Bedienungsanleitung PDF herunterladen (Seite 29)

Altera Corporation 29

MAX 9000 Programmable Logic Device Family Data Sheet

Notes to tables:

(1) See the Operating Requirements for Altera Devices Data Sheet.

(2) Minimum DC input on I/O pins is –0.5 V and on the four dedicated input pins is –0.3 V. During transitions, the

inputs may undershoot to –2.0 V or overshoot to 7.0 V for periods shorter than 20 ns under no-load conditions.

(3) V

must rise monotonically.

(4) Numbers in parentheses are for industrial-temperature-range devices.

(5) Typical values are for T

= 25° C and V

= 5.0 V.

(6) These values are specified under the MAX 9000 recommended operating conditions, shown in Table 15 on page 27.

(7) During in-system programming, the minimum V

of the JTAG TCK pin is 3.6 V. The minimum V

of this pin

during JTAG testing remains at 2.0 V. To attain this 3.6-V V

during programming, the ByteBlaster and

ByteBlasterMV download cables must have a 5.0-V V

(8) This parameter is measured with 50% of the outputs each sinking 12 mA. The I

parameter refers to high-level

TTL or CMOS output current; the I

parameter refers to the low-level TTL or CMOS output current.

(9) JTAG pin input leakage is typically –60 µΑ.

(10) Capacitance is sample-tested only and is measured at 25° C.

(11) Measured with a 16-bit loadable, enabled, up/down counter programmed into each LAB. I

is measured at 0° C.

Figure 13 shows typical output drive characteristics for MAX 9000 devices

with 5.0-V and 3.3-V V

CCIO

Figure 13. Output Drive Characteristics of MAX 9000 Devices Note (1)

Note:

(1) Output drive characteristics include the JTAG TDO pin.

Table 20. MAX 9000A Device Typical I

Supply Current Values

Symbol Parameter Conditions EPM9320A EPM9560A Unit

CC1

supply current (low-power mode,

standby, typical)

= ground, no load (11) 99 174 mA

12345

150

120

CCIO

= 5.0 V

Room Temperature

12345

150

120

CCIO

= 3.3 V

Room Temperature

3.3

ypical I

utput

urrent (mA)

Output Voltage (V) Output Voltage (V)

Typical I

Output

Current (mA)

5.0-V 3.3-V

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 45 46

Kommentare zu diesen Handbüchern

Keine Kommentare

Z Microsystems ZX3 Bedienungsanleitung Seite 29

Kommentare zu diesen Handbüchern