Z-microsystems 21 Bedienungsanleitung PDF herunterladen (Seite 6)

Doc# 27-0017UM Issued 08/03 Rev 1.0

6

STARTING POINT

TOOLS REQUIRED FOR INSTALLATION

PRECAUTIONS

Required Tools and Equipment:

• Flathead screwdriver with about

10" shaft.

• Phillips screwdriver with about 10"

shaft.

• Adjustable wrench or box wrenches.

In preparation to install the Glider, take

the following precautionary steps:

• Turn off the electrical power to your

computer.

• Verify the Glider power switch is off.

If the Glider is off, the Power light on

the display front will not be illumi-

nated and the power switch will be

down toward the circle.

WARNING: To avoid shock

hazard:

• Do not remove the covers

around the Glider.

• Do not connect or

disconnect the Glider

during an electrical

storm.

• The power cord plug must

be connected to a

properly wired and

grounded power outlet.

• Any equipment to which

the Glider will be

attached must also be

connected to properly

wired and grounded

power outlets.

• The socket outlet shall be

installed near the

equipment and shall

be easily accessible.

NOTE: For the fastest and

easiest installation of

the Glider, follow these

steps in the sequence

they are presented.

1 2 3 4 5 6 7 8 9 10 11 ... 33 34

Kommentare zu diesen Handbüchern

Keine Kommentare