Z Microsystems 21 Bedienungsanleitung PDF herunterladen (Seite 12)

1227-0045UM REV B Issued 02/12

NOTE: If Touch Panel is not responding

accurately, in addition to the Microchip Touch

Screen Controller calibration, the Touch

Panel may need to be calibrated through the

calibration resource in your operating system.

NOTE: If the Touch Panel is not responding,

open the ‘Universal Pointer Device Driver

(UPDD)’ Control Panel and update the COM

port setting.

CONNECTIONS & SETUP

Setup Process for Touch Panel (Continued)

Step 3

- Install and Setting the TSHARC Touch Panel Driver COM port

Select Microchip, TSHARC-X/X, Serial Option and the respective Port COM setting. Once complete, Click

on the Install button.

Upon successful installation of driver, reboot computer if necessary. If the touch panel is not respond-

ing, open the ‘Universal Pointer Device Driver (UPDD)’ Control Panel and update the COM port setting.

Indicate which Port number your touch panel is connected to and test again.

Step 4 - Conguring the TSHARC Touch Panel driver

For basic Touch Panel operation, proceed to the ‘Universal Pointer Device Driver (UPDD)’ Control Panel.

The UPDD control panel allows the user to set calibration and other touch panel device properties. Com-

plete the following steps for key setup and calibration requirements:

To use the Touch Panel with Click and Drag settings - Select “Click Mode” tab from the menu on the left,

then verify the hardware is congured to Click and Drag in the pull down menu.

Step 5 - Calibration of the Touch Screen Controller

Select the “Calibrate” tab and follow the on-screen guide to ensure the touch screen controller is properly

calibrated for your display. Calibration window is illustrated below.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Keine Kommentare

Z Microsystems 21 Bedienungsanleitung Seite 12